Information on managing the Z-Wave interfaces connected to your HomeSeer platform.

Overview

From the Manage Interfaces page, you can add, edit, enable and disable your Z-Wave interface(s). 

Navigation

Access the Manage Interfaces page from Plugins > Z-Wave > Manage Interfaces

Options

Adding a Z-Wave Interface

To add a Z-Wave interface, click the Add Z-Wave Interface button seen above. Please see our guide on adding Z-Wave interfaces for instructions on that process.

Editing Interfaces

An enabled Z-Wave interface has a red power icon and the buttons to edit or delete it are grayed out. To edit or delete an interface, click the red power icon and it will turn green.

Changing Z-Wave Frequency

The HT-PI-G3, Z-NET-G3 and SmartStick+ G3 all allow for changing the frequency of the Z-Wave chip. 

  1. Click the Set Interface Region icon.
  2. In the pop-up change the drop-down menu to the locale that matches the frequency necessary. (see the table below for frequency listings)
  3. Click save when finished.

Frequencies

Frequency (MHz)Used In (Locale)
865.2India
869Russia
868.4China, Singapore, South Africa
868.4, 868.42, 869.85CEPT Countries (Europe and other countries in region), French Guiana
908.4, 908.42, 916USA, Canada, Argentina, Guatemala, The Bahamas, Jamaica, Barbados, Mexico, Bermuda, Nicaragua, Bolivia, Panama,

British Virgin Islands, Suriname, Cayman Islands, Trinidad & Tobago, Colombia, Turks & Caicos, Ecuador, Uruguay

916Israel
919.8Hong Kong
919.8, 921.4Australia, New Zealand, Malaysia, Brazil, Chile, El Salvador, Peru
919–923South Korea
920–923Thailand
920–925Taiwan
922–926Japan

Notes

If you run into issues managing your interfaces, you can show the Legacy Z-Wave menu and access the legacy method of managing interfaces from Plugins > Z-Wave > Controller Management